#Max ram for macbook pro mid 2010 install#
#Max ram for macbook pro mid 2010 code#

#Max ram for macbook pro mid 2010 install#

If you have Fill these slots Two DIMMs 1 and 2 Three DIMMs 1, 2, and 3 Four DIMMs 1, 2, 3, and 4 (all) Note:В If you install different sized DIMMs in your Mac Pro, follow the order in the table above.

If you are installing equal-size DIMMs (all 2 GB or all 4 GB) in your Mac Pro, Apple recommends that you fill the slots in the order listed in the table.

Remove the processor tray and lay it on a soft, clean cloth on the desk or work surface, to protect the tray and avoid scratching the work surface.Pull the latches until they open all the way and release the processor tray.Push the latches on the processor tray until they partially open.In a Quad-Core or 6-Core Mac Pro (Mid 2012):вЂ‹ Important:В Hold the side panel securely wile you remove it. Remove the side panel by pulling the top away from your Mac Pro and lifting up.Hold the side panel and lift the latch on the back.Don't attempt to install items while it's plugged in. Note:В To avoid damaging internal components or the components you want to install, always unplug your Mac Pro. Unplug all the cables and the power cord from your Mac Pro.Buy 16Gb 2X8Gb Ram Memory Compatible with Apple Macbook Pro Core 2 Duo 2.66 13' Mid-2010 By CMS A15: Memory - вњ“ FREE. The actual maximum RAM of each MacBook Pro is listed below along with its compatible RAM type, default amount of RAM pre-installed, common identifiers suitable to identify a MacBook Pro in order to determine its RAM capacity, and more. Mac Specs > By Capability > Actual Maximum RAM > MacBook Pro Models. To avoid generating static, don't move around the room until you finish installing the cards, memory, or internal storage device and replace the side panel. Note:В Always discharge static before you touch parts or install components inside your Mac Pro. Touch the metal on the outside of your Mac Pro to discharge any static electricity.Warning:В Let your Mac Pro cool down before you touch the internal components, which may be very warm. Wait 5 to 10 minutes to allow the internal components of your Mac Pro to cool.

Note:В Always shut down your Mac Pro before opening it to avoid damaging its internal components or the components you want to install.Дo not open your Mac Pro or attempt to install items inside it while it is on.

Before you open your Mac Pro, shut it down by choosing Shut DownВ from the AppleВ (пЈї)В menu.

The computer will not start if both types of DIMMS are installed in the same computer. Note: Although the memory speed of the UDIMMS is 1333 MHz, they will operate at 1066 MHz or1333 MHz depending on the processor in the computer. You can purchase Apple-branded memory online from the Apple Store. DIMMs from older Mac computers cannot be used in your Mac Pro.

#Max ram for macbook pro mid 2010 code#

Mac Pro (Mid 2012) computers have these memory specifications: Quad-core or 6-core 8-core or 12-core Number of processors 1 2 Number of memory slots 4 8 Base memory 6 GB 8 GB Maximum memory 32 GB 64 GB Memory card specifications - PC3-10600E, 1333 MHz, DDR3 SDRAM UDIMMs and RDIMMs - Error-correcting code (ECC) - 72-bit wide, 240-pin ECC modules - 36 ICs maximum per ECC UDIMM Additional notes Important:В Apple recommends that you use Apple-approved DIMMs.